Filter
Top Products
TechniSat ST 6002 S
6.2. Connecting a Videorecorder or Decoder
Connection of a Videorecorder
To record the signal of the ST 6002 S you can connect the videorecorder either to the “VCR/Dec”
scart socket or to the UHF output. It is also possible to use the video/audio phono sockets.
Make sure that you have a direct connection from the videorecorder to the TV set in accordance with
the diagrams below:
Connection of a decoder
The coded reception signal is sent from the “VCR/Dec” scart socket to the decoder. The decoded sig-
nal is sent back to the receiver and can be picked up at the TV scart socket or at the UHF output
connection. Therefore connect the decoder at the “VCR/Dec” scart socket as shown above.
The output signals for a decoder can also be picked up at the audio/video phono sockets.
22
RF IN
CH
UHF OUT
+
-
LNB PWR OUT
DC 14/18V
400 mA MAX
(
(
I
B/G
TSG
VIDEO
ANT IN
B(R)-AUDIO-(L)A
DECODER VIDEO
EURO SCART FOR VCR/DECODER
EURO SCART FOR TV
GND PULSE +5V M2 M1
50 mA MAX 36V 1,5 A MAX
EXT BUS
+ FERRIT –
82 ohm, ± 45 mA MAX
220V 240V
F1
F2
FUSE
250V T500mA
FUSE
250V T500mA
AC 240V 50 Hz
110 WATTS MAX
SCART
(EURO AV)
B(R)-AUDIO-(L)A
DECODER VIDEO