Filter
Top Products
TechniSat ST 6002 S
8.6 Changing Channel Parameters
8.6.1. Video Menu:
To change the present video parameters first press the VIDEO
button on the RCU. The video menu appears on the screen.
Now you can change the following parameters:
"IF tune" - IF (950 - 2050 MHz) which can be
keyed in directly
"B/W" - Video bandwidth, 18/27 MHz selec-
table. Switch to narrow (18 MHz)
for reception of weak signals.
"Level" - You can alter the video level (1 - 4) to
change the channel brightness.
"Video-Pol" - You only change the video polarisation
to "inverted" for C-band reception or for
some special decoders.
"Decoder" - If you wish to connect a decoder to your
ST 6002 S, switch to "External". Then
the coded reception signal will be sent
from the VCR/Dec. scart socket to the
decoder. The decoded signal will be sent
back to the receiver and can be picked
up at any output.
If you have chosen "External", you can
select between 4 different decoder sig-
nals depending upon the decoder being
used.
You can also switch to "External" if you
wish to throu-loop the playback of a video
recorder to your TV.
If you wish to store the changes, leave the video menu using
ENTER. If not, press CNCL.
NOTE:
The respective signal strength is also displayed on the
screen. The weaker the signal is, the greater the negative value.
37