Filter
Top Products
ENGLISH
9
In this manual we only refer to the buttons on the cassette deck
itself. However, their remote counterparts can be used in the
same way.
Power switch
This switch toggles the unit on/off.
Reverse mode switch (REV MODE)
This switch is used to switch between reverse modes.
TIMER switch
This switch is provided for use with a commercially available
audio timer, to allow timer controlled recording or playback.
Normally, leave this switch to the OFF position.
DOLBY NR switch
This switch toggles the Dolby Noise Reduction system on/off.
In playback you need to set this switch to the same position
as when the recording was made.
TAPE I compartment
Remote sensor
This receives remote commands. When using the remote
control unit, point it at this sensor.
Counter clear buttons (CLEAR I and CLEAR II)
Pressing these buttons reset the tape counter readings for
TAPE I and TAPE II, respectively.
INTRO CHECK button
Pressing this button allows you to identify recorded segments
by listening to the first 15 seconds of each segment.
Synchro reverse button (SYNC REV)
Pressing this button activates the synchro reverse dubbing
function.
BLANK SCAN button
This button toggles Blank Scan on/off.
Display
This shows tape counters, level meters, etc.
Parallel record button (PARALLEL REC)
This button lets you simultaneously record on both decks.
Dubbing start button (DUB START)
This button is used when copying the contents of a tape from
TAPE I to TAPE II, either at normal or high speed.
On the remote control unit a pair of buttons is provided for
each speed. You need to press both buttons at the same
time.
M
L
K
J
I
H
G
F
E
D
C
B
The equipment draws nominal non-operating power from
the AC outlet with its POWER switch in the OFF position.
A
TAPE II compartment
EJECT buttons
Pressing these buttons opens the TAPE I and TAPE II
compartments.
Tape transport control buttons
RECORD
Pressing this button shifts the corresponding deck to record-
pause mode.
When you use the remote control unit, you need to press a
pair of buttons at the same time to shift either deck to record-
pause mode.
PAUSE
Pressing this button temporarily stops playback or recording.
Recording mute (REC MUTE)
This button is for creating the 4-second blank space needed
for proper operation of the Computomatic Program Search
(CPS) function.
m
/,
Fast-forward/Rewind
H
Stop of playback/record
h
/ y
Reverse side play/Forward side play
Headphones jack (PHONES)
Plug your headphones into this jack.
PITCH CONTROL
This control is used to vary the playback speed.
REC LEVEL control
This control is used to adjust the recording level.
MIC jack and level control
Insert your microphone into this jack and use the knob to
adjust the level of mic input.
<
The MIC jack is mono. You cannot use a stereo microphone
with this cassette deck.
T
S
R
Q
P
O
N