Filter
Top Products
ENGLISH
23
Press the SYNC REV button.
The SYNC REV indicator will light on the display.
<
The SYNC REV button does not work if the reverse mode is
set to any positions other than “j
” or if the transport
direction of both decks is not set to forward (y
).
Press either DUB START button to start dubbing.
For normal speed dubbing, press the NORMAL button.
For high-speed dubbing, press the HIGH button.
High-speed dubbing makes a copy at approximately two
times the normal speed. We recommend normal speed
dubbing for best audio quality.
During dubbing, either the NORM DUB or HIGH DUB
indicator lights steadily on the display.
<
During normal speed dubbing, only the following buttons
work:
TAPE I deck: STOP (H)
TAPE II deck: PAUSE, REC MUTE, STOP (H
)
During high-speed dubbing, only the stop button (H
) works.
5
4
< Pressing the stop button (H) on either deck stops both tapes
at once.
< Neither DUB START button works immediately after the tape
is fast-forwarded or rewound to the end. Wait for 5 seconds
or more before pressing the button.
<
During dubbing, the pitch control does not work.
<
Recording level adjustment is not necessary for dubbing, as
the recording level is set to the level of the pre-recorded tape.
Operating the REC LEVEL control, before or after starting
dubbing, has no effect at all.
<
If a nearby television set is switched on during high-speed
dubbing, a high-pitched interference noise may be recorded
on the tape. To avoid this, either perform dubbing at normal
speed, or turn off the television.