Select a reverse mode setting using the REV MODE
switch.
You have a choice of three settings:
u
: One way mode
Set the switch to this position to play back only one side.
j
: Two way mode
Set the switch to this position to play back both sides of
the tape in one session. When playback reaches the end of
side “A”, the playback direction is automatically reversed,
and playback continues on side “B”.
p
: Repeat mode
Set the switch to this position and both sides of the tape
are played back as many as 5 times.
Set the DOLBY NR switch.
Set the switch to the ON position when playing back tapes
recorded with Dolby NR.
To play tapes recorded without Dolby NR, set the switch to
the OFF position.
Press the play button (h or y).
y
: Pressing this button starts playback from side “A”.
Playback stops when reaching the end of side “A” if the
reverse mode is set to u
. If the reverse mode is set to
j
, playback continues on side “B”, stopping at the end
of side “B”. If the reverse mode is set to p
, playback
cycles through both tape sides 5 times.
h
: Pressing this button starts playback from side “B”.
Playback stops when reaching the end of side “B” if the
reverse mode is set to either u
or j. If the reverse
mode is set to p
, side “B” is played back, and then
playback cycles through both tape sides 4 times.
5
4
3
ENGLISH
11
Playback (either TAPE I or TAPE II) 1
13
4
2 2
5 5
Switch on the power.
Load a pre-recorded tape into the TAPE I or II deck.
Press the EJECT button (L) to open the cassette
compartment. Insert the cassette tape with its open edge
facing down, the desired side facing you. Then, close the
cassette compartment by pushing on its front part.
<
This cassette deck can play back Normal (Type I), Chrome
(Type II) and Metal (Type IV) tapes.
For the sake of simplicity, we refer to the tape side facing you
as Side “A” and to the tape side facing away as Side “B”.
When you insert a cassette with Sides “A” and “B” reversed,
Side “A” should read Side “B” and Side “B” should read Side
“A”.
2
1
Side “A” facing you