Filter
Top Products
ENGLISH
25
Troubleshooting
If you think that there is something wrong with this cassette
deck, make the checks listed below before contacting a repair
service. In some cases the problem may lie with another
component. Check all components.
If the problem cannot be solved with any of the following
checks, contact your nearest TEAC authorized service center or
your dealer for help.
Cannot switch on the power.
e
Check the connection to the AC power supply. Check and
make sure the AC source is not a switched outlet and that,
if it is, the switch is turned on. Make sure there is power to
the AC outlet by plugging another item such as a lamp or
fan into the outlet.
No sound
e
Check the connection to the amplifier.
e
Check the amplifier settings.
The remote control does not work.
e
Check that the deck is powered on.
e
If the batteries have run out, replace both batteries.
e
If there are obstacles between the deck and remote control,
remove them. Point the remote control at the remote sensor
of the deck from a distance of less than 5 meters.
e
If the remote sensor of the deck is exposed to direct sunlight
or very bright light, the remote control may not work. If this
is the case, use the control buttons of the deck itself instead.
Noisy playback
e
Keep away from equipment that generates a magnetic field,
such as a TV or microwave oven.
Transport control buttons don’t work.
e
Load a cassette tape if not loaded.
e
If a cassette tape is loaded, reinsert it.
The cassette compartment does not close.
e
The cassette is not properly loaded. Reinsert it.
Poor sound quality
e
Clean the heads.
e
Check that the Dolby NR switch is set to the same position
as when recording was made.
Cannot record.
e
If the erasure prevention tabs on top of the cassette are
broken off, cover the holes using pieces of adhesive tape.
e
Check the connection to the amplifier and to the source
equipment.
e
Set the amplifier input/output selectors correctly.
e
Check the recording level setting.
Playback speed seems somewhat fast or slow.
e
Check the pitch control setting.
Auto reverse does not occur
e
Set the REV MODE switch to “j” or “p”.
e
If the REV MODE switch is set to “j”, start playback from
the tape side facing you (side “A”).
Synchro reverse dubbing is not possible.
e
Set the REV MODE switch to the “j” position.
e
Load cassettes into both decks.
e
Set the tape transport direction to y on both decks.
Continuous play/record is not possible.
e
Set the REV MODE switch to the “p” position.
e
Load cassettes into both decks.
e
To make a continuous recording, start with TAPE I.
This cassette deck operates on a delicate microcomputer
and there may be occasions when the deck does not
function as expected because of external noise or
interference. Problems you encounter on such occasions
may be cured by turning off the power, waiting for 1
minute or more, then turning the power back on.