Filter
Top Products
16
Recording (either TAPE I or TAPE II)
13
4
2 2
5 5
8 8A A
67 7
Turn on the power.
Load a tape for recording.
Press the EJECT button (L) to open the cassette
compartment. Insert the cassette tape with its open edge
facing down, side “A” facing you. Then close the cassette
compartment by pushing in the cassette door until it clicks
shut.
<
If the erasure prevention tabs of the loaded cassette tape
have been broken off, stick a piece of adhesive tape over the
hole(s).
<
With this cassette deck you can use Normal (Type I) and
Chrome (Type II) tapes for recording.
Set the REV MODE switch.
u
: Set to this position to record on one side only.
j
or p: Set to either of these positions to record on both
sides.
Set the DOLBY NR switch.
Set the switch to ON to record with Dolby Noise Reduction.
Set to OFF to record without Dolby Noise Reduction.
4
3
2
1
Press the RECORD button.
The deck enters the record-pause mode. “J” and “ ”
will light on the display.
Adjust the recording level.
Start playback of your recording source and set the REC
LEVEL control knob so that the level meter indicates “0 dB” at
peaks.
Set the recording direction.
Recording is made in the direction indicated by the
play/record direction indicator (h
or y). To change this
direction, press the opposite direction play button (h
or y).
When everything is ready, start recording by pressing
the PAUSE button or the play button whose arrow
points in the same direction as the indicator.
<
To record on both tape sides, set the REV MODE switch to
“j
” or “p” and press the forward play button (y). If
you press the reverse play button (h
), recording will be done
only on side “B”.
<
To stop recording, press the stop button (H).
8
Be careful not to press play button whose arrow points in
the same direction as the indicator. Doing so will start
recording.
7
6
REC
5
Side “A” facing you