Teac Network USB DAC Integrated Amplifier Stereo Amplifier User Manual


 
3232
For detailed information about compatibility, see page 10.
p The following explanations refer to an iPod, but they
also apply to use with an iPhone or iPad.
1
Press the SOURCE button repeatedly to
select “USB/iPod”.
p The remote control’s USB/iPod button can also be
used.
p “Not Connected” will appear when no iPod is
connected.
2
Connect an iPod to this unit using the USB
cable supplied with the iPod.
The iPod automatically turns on and starts playback
from the iPod music list.
Listening to an iPod/iPhone/iPad (1)
p When the iPod is connected while a mode other
than iPod/USB mode is selected in the NP-H750, the
iPod will turn on and enter pause mode.
p If an iPod is connected to this unit, it will only be
recharged when this unit is ON.
p Recharging will stop when the iPod is fully recharged.
p Recharging is not possible when this unit is in standby.
Pausing playback
Press the play/pause button (G/J) to pause playback.
Playback stops at the current position.
To resume playback, press the play/pause button (G/J)
again.
Skipping to the next or previous file/
track
During playback or when paused, press the skip buttons
(.//) repeatedly until the desired file/track is found.
p When the . button is pressed during playback, the
file/track being played will be played from the begin-
ning. If you want to play the previous files/tracks, press
the . button twice or more.