Filter
Top Products
36 TASCAM CC-222MKII Owner’s Manual
7 – Reference and specifications
Troubleshooting
Symptom Possible cause and remedy
No power when
POWER
is pressed
The power cord is not inserted properly. Check and correct this.
Hum on playback Audio connections not made properly. Check the connections
No audio output The external amplifier is not properly connected, or the wrong set of inputs connected to
the active
LINE OUTPUT
s has been selected on the amplifier. Check and correct.
The remote control does not seem to work Is the power on? Are the batteries in the remote control dead? Is the remote control unit
too far away or at the wrong angle for correct operation (“Use of the remote control unit” on
page 10)?
Low sound quality when playing back a tape The heads are dirty or magnetized. See “Tape maintenance” on page 39.
Sound is odd when playing back a tape Pitch control may be off center (“Pitch control” on page 19)
Tape recording cannot be carried out The write-protect tabs have been broken off the cassette, the heads are dirty, or the
recording level is set too low.
Hum appears at the
PHONO
input
The grounding wire is not connected from the record deck to the CC-222MKII.
No sound on playback (the disc is playing and
the time display is incrementing)
The connections from the CC-222MKII to the amplifier system have not been made prop-
erly, or the input source selector is not at the correct position.
No meter indication when a source is input Analog and/or digital volume (“Signal volume” on page 25) is set too low. The signal is
being input through an unselected input source (“Input selection” on page 25)
or
The input selection is not made correctly (“Recording operations” on page 17 (tape) or
“Input selection” on page 25 (disc).
There is a gap in the A-B loop when played
back
The A and B points are in different tracks.
The unit is in AUTO SPACE mode and is not
playing (it is paused)
When the unit is automatically paused as a result of the auto space mode, pressing the
AUTO SPACE key puts the unit into pause mode, and playback does not resume automat-
ically after the auto pause time is elapsed (see “Auto spacing” on page 24).
D-IN UNLOCK! A digital input source has been selected for CD recording, but the source is not connected
or is not switched on.
Cannot record on a disc (pressing
RECORD
shows MONITOR)
A finalized disc has been inserted. Use an unfinalized recordable disc.
PGM Full ! An attempt has been made to create more than 25 program steps.
Disc Full!
or Cannot Rec!
There is no space on the disc, or no tracks are available, or a general recording error has
occurred.
Disc Error The disc is bad. If it is a CD-RW disc, you may refresh it (“Refreshing a disc” on page 34),
otherwise replace the disc.
Erase Error! An error has occurred while trying to erase the disc.
The display suddenly shows PMA Writing Either the disc is full (this message will be prefaced by
Disc Full!!
(“Full
disc” on page 27) or an attempt has been made to write more than 99 tracks.
Rec Error General recording error. This may be caused by vibration or a shock during recording, for
example, or may be the result of a bad disc. Try recording again with the same disc. If the
message appears again, try a different disc.
System Err! System error.
Drive Error! Error in the CD drive mechanism.