Filter
Top Products
5 – Recording CDs—Advanced recording
32 TASCAM CC-222MKII Owner’s Manual
NOTE
This function is only available from the remote control
unit. It is not possible to use this function with the main
unit only.
Fade-in and fade-out
To provide smooth beginnings and endings to
recorded tracks, the unit provides fade facilities.
Fade-ins are from –∞ (silence) to the set input level
(“Signal volume” on page 25) and fade-outs go from
the current input volume to silence.
The fade-in and fade-out times can be set indepen-
dently in increments of one second, from 1 second to
24 seconds.
To set the fade times:
1 Press the
MENU key repeatedly until the dis-
play shows
FADE IN > XXS, where XX
is the current fade-in time, in seconds.
2 Turn the
MULTI DIAL or use the SKIP keys to
change the value of the fade-in time.
3 Press the
MENU key again so that the display
shows
FADE OUT> XXS, where XX is
the current fade-out time, in seconds.
4 Turn the
MULTI DIAL or use the SKIP keys to
change the value of the fade-out time.
It is possible to set the fade-in time only (per-
form step 5 after step 2) or the fade-out time
only (in step 1, press the
MENU key until the
fade-out time menu item is shown).
To perform a fade-in:
1 With a recordable disc loaded, press the
RECORD key so that the unit enters record
ready mode.
2 Start the source material, and press the
FADER key.
The display shows
FADE IN for the time
specified in the menu item above.
As the fade progresses, the monitored signal
gradually becomes louder, reflecting the level
recorded on disc.
To perform a fade-out:
1 While recording, press the FADER key.
The display shows
FADE OUT for the time
specified in the menu above.
As the fade progresses, the monitored signal
gradually becomes quieter, reflecting the
level recorded on disc.
2 When the end of the fade-out time is reached,
the unit goes into record ready mode.
Recording can be restarted with the
FADER
key or the
PLAY or PAUSE keys.
The fade-in and fade-out times can be reset to new
values while recording is in progress.
Note that fade operations cannot be carried out when
auto track is enabled.