Filter
Top Products
TASCAM CD-302
7
1 - Before you start
1.1 Main features
• Two high-quality precision CD decks in a single
rack-mountable unit.
• RCA unbalanced outputs for each deck
• Dedicated per-deck remote control units
(detachable and rack-mountable)
• 10 seconds of anti-shock memory per deck.
• Instant start
• Large jog dial for frame-accurate cue point search-
ing
• Selectable tempo and key control range : ±8%,
±16%, or ±32% (or disabled).
• Key control function allows changing key without
affecting the original tempo
• Key control mode in percentage or semitone steps
• Original Key function allows tempo change while
maintaining the original key
• Pitch control to change both tempo and key
• 100 mm tempo slider
• 10 seconds’ sampling function (per deck)
• 3-way loop functions: A-B, SINGLE, and ALL
• Seamless loop function in A-B loop
• Automatic BPM (beats per minute) count function
and BPM counter
• Tempo sync between the decks
• Beat sync between the decks
• TAP function for manual BPM settings
• Bend function allows adjusting of beats manually
between the two decks
• Brake function allows braking in exactly the same
way as on a record turntable
• Scratch function allows scratch play
• Voice Reduce function lowers the level of the vocal
part
• Up to 1,000 track memories. Tracks can be memo-
rized in 5 banks (200 tracks each, Bank A to E)
• Up to 24 parameters can be set as user-definable
memory functions (various settings)
• Output level control in the digital domain (±6 dB,
in 1.0 dB steps).
• Selectable Elapsed and Song Remain time display
• Continuous play
• Single play
• Program play
• Auto cue function (–72, –66, –60, –54, or –35 dB)
• Auto ready function to cue up following tracks
• End of Message function (10, 15, 20, 30, 60, or 90
seconds).
• Timer play for deck 1 followed by deck 2.
• Relay play allows consecutive playback using both
decks (as one deck stops, the other can be set to
start automatically).
• Sleep function (automatic shutdown of the deck
after 30 minutes of inactivity)
• Tray auto close function can close the tray auto-
matically one minute after the tray is opened
• Incremental play
• Event start
• Fader start
1.2 Environmental conditions
The TASCAM CD-302 may be used in most areas,
but to maintain top performance, and prolong operat-
ing life, observe the following environmental
conditions:
The nominal temperature should be between 5˚C and
35˚C (41˚F and 95˚F).
Relative humidity should be 30 to 90 degrees non-
condensing.
Make sure that the drive unit is mounted in a level
position for correct operation.
The units should be mounted, using the supplied rack
mounting kits. A typical configuration is shown
below, but other configurations are possible:
NOTE
If the disc trays are more than 5 degrees away from
the horizontal, they will not open or close.