Filter
Top Products
4 • Advanced Operations—Output level
TASCAM CD-302 27
2 Select 11 PROG (
PROG
) using the dial or
numeric keys.
3 Press the ENTER key. The track number, fol-
lowed by the program step number (e.g.
Pro
05
(
PRO 05
)), is shown on the display.
4 Use the dial to select the position in the pro-
gram where the new program step is to be
inserted.
5 Use the
SKIP keys C to select the track to be
played as the program step which will be
inserted.
6 Press the
ENTER key. All program steps follow-
ing the step which has just been entered will
have 1 added to their step numbers.
7 Repeat 5 and 6 above for as many steps as will
be inserted into the program.
8 To finish the program entry sequence, press
the
PRESET or ENTER key (or any key except
the
SKIP keys).
4.12.3 Deleting program steps
This function allows you to delete individual pro-
gram steps from the program.
1 Press the
PRESET key.
2 Select
11 PROG (
PROG
) using the dial or
numeric keys.
3 Press the
ENTER key. The program step num-
ber and the track number are shown on the
display.
4 Use the dial to select the track to be deleted.
5 Use the
SKIP keys C to select E
(
E
) (“before”
the first track).
6 Press the
ENTER key to delete the track. Pro-
gram steps following the deleted program step
will 1 subtracted from their step numbers.
7 Repeat steps 5 and 6 for as many tracks as are
to be deleted.
8 To finish the program step deletion sequence,
press the
PRESET or ENTER key (or any key
except the
SKIP keys).
4.12.4 Deleting a whole program
This procedure deletes the whole of the program (all
the program steps).
1 Press the
PRESET key.
2 Select
11 PROG (
PROG
) using the dial or
numeric keys.
3 Press the ENTER key. The program step num-
ber and the track number are shown on the
display.
4 Use the dial to display
PRO E (
PRO E
).
5 Press the
ENTER key. The display will show
-SuRE-
(
-SURE-
).
6 Press
the ENTER key one more time to delete
the whole program.
NOTE
Opening the disc tray will also clear the whole of the
program.
4.13 Output level
You can adjust the output level digitally in steps from
+6 to –6, or set to
nor (
NOR
=normal).
The
nor setting is equivalent to the
+6
setting (max-
imum output level is 2 Vp-p). The maximum output
level of the 0 setting is 1 Vp-p. The amplification
chain must be used to make up volume if required.
1 Press the
PRESET key.
2 Select
12 OUTPUT (
OUTPUT
) using the dial or
numeric keys.
3 Press the
ENTER key.
4 Use the dial to select the value by which the
output level will be cut or boosted.
5 Press the
ENTER key to confirm the setting.
4.14 Brake function
Brake function allows the braking of the audio just
like turning off an analog record turntable.