Filter
Top Products
9-23
DFP-3000
9.6.2 Connecting the DFP-3000 to the CP-500 with the CP-500 as master.
When using the CP-500 as the master, use the DFP-D3000 for only the playback of the SDDS. This
setting has the following problems.
1. The CP-500 input and output are unbalanced while those of the DFP-D3000 are balanced, therefore
compared to the CP-500, effects of external noises are less.
2. The powerful theatre control features and easy setup of the A- and B-chain of the DFP-3000 will be
disabled.
3. Channel level trims of the CP-500 will affect the SDDS channels.
4. The CP-500 analog bass and treble controls will also affect SDDS playback.
However, when using the CP-500 as the master in consideration of the ease of operations, set the CP-500
and DFP-D3000 as follows.
1. System configuration
2. Logic wiring connections
DFP-D3000 Automation I/O Connector CP-500 Automation Connector
(D-sub connector, 37 pin, Female) (D-sub connector, 25 pin, Female)
Pin No. Function Pin No. Function
Pin 16 Tally Common Pin 12 Signal Ground
Pin 32 SDDS Data OK Pin 6 SK6 Format Select Input (Note.)
- Wired to -
Pin 11 Preset 8 select
Pin 36 SDDS Data not OK Pin 4 SK4 Format Select Input (Note.)
n
These connections are valid only if the Dolby Digital format is assigned to SK4 and SDDS (User 1 or
higher) is assigned to SK 6 on the CP-500. On the DFP-D3000, SDDS must be assigned to Preset 8.