Filter
Top Products
9-12
DFP-3000
9.5 Description on Connection of DA-20 and DFP-D3000
9.5.1 Outline of System
9.5.2 Requirements at SDDS Side
If the DFP-D3000 software is V2.21 or above, the SDDS can be controlled using the method described in
this manual.
Check the software version at the Status screen of the DFP-D3000 menu. For details on operating the
DFP-D3000 menu, refer to the DFP-D3000 operation manual.
9.5.3 Connection to the DA-20 and Setting the Operation Mode
Using the J8 (CP Audio Conn.) terminal (25-pin D-sub connector) for the Dolby Laboratories DA-20,
connect signals from here to the DFP-D3000 AUX INPUT1 or AUX INPUT 2 connector. As the DA-20
unit uses a male connector, prepare a cable with a female connector.
Using the J6 (Sense/Control) terminal (25-pin D-sub connector) as the DA-20 side control signal output
terminal, connect signals from here to the DFP-D3000 Automation connector. As the DA-20 unit uses a
male connector, prepare a cable with a female connector.
For this connection, the DA-20 operation mode must be set to the CP-200 mode (position 3).
The switch for this setting can be accessed without opening the cover. (It is the blue rotary digital switch
which can be seen from the front panel operation side.)
Amp.
Dolby Digital
Decoder
DA-20
DFP-D3000
Automation
System Out
AUX1 / AUX2
DFP-R3000
Analog Reader
Dolby Digital
Reader
Reader
Opt1 / Opt2