Filter
Top Products
38
GB
To register more than one set of
settings for the listening
environment
You can select the seating position you want
and register the measurement results of the
Auto Calibration for that seating position.
1 Press AMP MENU.
2 Press V/v repeatedly to select “AUTO
CAL”.
3 Press or b to enter the menu.
4 Press V/v repeatedly to select
“POSITION”.
5 Press or b to enter the parameter.
6 Press V/v repeatedly to select the
position (POS. 1, 2, 3) for which you
want to register the measurement
results, then press .
7 Press V/v repeatedly to select “A.CAL
START”, then press to perform
Auto Calibration.
You can also use AUTO CAL on the
remote. For details, see “Performing Auto
Calibration” (page 34).
The measurement results is registered as
the position you selected in step 6.
8 Repeat step 1 to 7 to register another
seating position.
To select the registered seating
position
1
Press AMP MENU.
2 Press V/v repeatedly to select “AUTO
CAL”.
3 Press or b to enter the menu.
4 Press V/v repeatedly to select
“POSITION”.
5 Press or b to enter the parameter.
6 Press V/v repeatedly to select position
(POS. 1, 2, 3) you want, then press .
The registered seating position is selected.
To exit the menu
Press MENU/HOME or AMP MENU.
x NAME IN (Naming inputs)
You can rename the position name.
To name the position
1
Select the position (POS. 1, 2, 3) for
which you want to name.
2 Press V/v repeatedly to select “NAME
IN”.
3 Press or b to enter the parameter.
The cursor flashes and you can select a
character.
4 Press V/v to select a character, then
press B/b to move the cursor to the
next position.
If you made a mistake
Press B/b until the character you want to
change flashes, then press V/v to select the
correct character.
Tips
•You can select the character type as follows by
pressing V/v.
Alphabet (upper case) t Numbers t
Symbols
• To enter a blank space, press b without
selecting a character.
5 Press .
The name you entered is registered.