Filter
Top Products
36
GB
When error codes appear
Check the problem of the error and perform
Auto Calibration again.
*1
xxx
represent a speaker channel
FFront
S Surround
SB Surround back
To perform Auto Calibration
again
1
Press .
2 Press V/v to select “RETRY? YES”,
then press .
When you select “PHASE INFO”
You can check the phase of each speaker (in
phase/out of phase).
Press V/v repeatedly to select a
speaker, then press to return to
step 2 of “Confirming/saving the
measurement results” (page 35).
*2
xxx
represent a speaker channel
FL Front left
FR Front right
CNT Center
SL Surround left
SR Surround right
SB Surround back
SBL Surround back left
SBR Surround back right
SW Subwoofer
Display Explanation
E -
xxx
*1
: 31 SPEAKERS is set to OFF. Set it
to others (page 32) and perform
the measurement again.
E -
xxx
*1
: 32 None of the speakers were
detected. Make sure that the
optimizer microphone is
connected properly and perform
the measurement again. If the
optimizer microphone is
connected properly but the error
code appears, the optimizer
microphone cable may be
damaged or improperly
connected.
E -
xxx
*1
: 33 • None of the front speakers are
connected or only one front
speaker is connected.
• The optimizer microphone is
not connected.
• Either the left or right
surround speakers is not
connected.
• Surround back speakers are
connected even though
surround speakers are not
connected. Connect the
surround speaker(s) to the
SURROUND terminals.
• The surround back speaker is
connected only to the
SPEAKERS SURROUND
BACK/BI-AMP/FRONT B R
terminals. When you connect
only one surround back
speaker, connect it to the
SPEAKERS SURROUND
BACK/BI-AMP/FRONT B L
terminals.
Display Explanation
xxx
*2
: IN The speaker is in phase.
xxx
*2
: OUT The speaker is out of phase. The
“+” and “–” terminals of the
speaker may be connected the
other way around. However,
depending on the speakers,
“
xxx : OUT” appears on the
display even though the
speakers are connected
properly. This is because of the
speakers’ specifications. In this
case, you can continue to use the
receiver.