Filter
Top Products
27
GB
Playing MDs
Changing the contents of the program
While the deck is stopped and “PROGRAM” lights up, do
steps 1 and 2 of “Programming the tracks” on page 26,
followed by one of the procedures below:
To Do the following:
Erase a track Press m/M repeatedly until the
number of the unwanted track flashes,
then press CLEAR.
Erase all tracks Press CLEAR repeatedly until all the track
numbers disappear.
Add a track at the
beginning of the
program
Press m repeatedly until “0” flashes
before the first track number, then do steps
3 to 5 of “Programming the tracks” on
page 26.
Add a track to the
end of the program
Press M repeatedly until “0” flashes
after the last track number, then do steps 3
to 5 of “Programming the tracks” on page
26.
Replace a track Press m/M repeatedly until the
number of the track to be changed flashes,
then do steps 3 to 5 of “Programming the
tracks” on page 26.
To resume normal play
Press PLAY MODE repeatedly until “PROGRAM” turns
off.
z
The program remains even after Program Play ends or is
stopped
Press H (or NX on the deck) to play the program again.
Notes
• If you eject the MD or disconnect the AC power cord, the
program will be lost.
• The display shows “- - - m - - s” when the total playing time of
the program exceeds 199 minutes.
• “ProgramFull!” appears when you program 25th track.
Checking the contents of the program
While the deck is stopped and “PROGRAM” lights up,
press DISPLAY repeatedly.
The first several tracks in the program appear in the
display. To see the rest of the program, press >
repeatedly.