Filter
Top Products
18
GB
Recording on MDs
4 Press MENU/NO.
The deck marks a track number whenever the input
signal level drops to –50 dB (the trigger level for
Automatic Track Marking) or below for at least 1.5
seconds.
To change the trigger level for Automatic Track
Marking
Do the procedure below to change the signal level that
triggers Automatic Track Marking.
1 While the deck is stopped, press MENU/NO twice.
“Setup Menu” appears in the display.
2 Press ./> repeatedly until “LS(T)” appears,
then press YES.
3 Press ./> repeatedly to select the level, then
press YES.
You can set the level at any value between –72 dB and
0 dB, in 2 dB steps.
4 Press MENU/NO.
z
Additional information on Automatic Track Marking
• When recording from a CD player or MD deck connected to the
DIGITAL (OPTICAL) IN1/2 connector, the entire material may
be recorded as a single track in the following cases:
— When you consecutively record the same track two or more
times using single-track repeat play.
— When you consecutively record two or more tracks with the
same track number but from different CDs or MDs.
— When you record tracks from certain CD or multi-disc
players.
Also, if the source is an MD, a track number may not be
marked for tracks less than four seconds long.
• When recording from a component connected to the LINE
(ANALOG) IN jacks with “T.Mark Off” selected or when
recording from a DAT deck or DBS tuner connected to the
DIGITAL (OPTICAL) IN1/2 connector, the entire material may
be recorded as a single track.
• When recording from a DAT deck or DBS tuner connected to
the DIGITAL (OPTICAL) IN1/2 connector, the deck will mark a
track number whenever the sampling frequency of the input
signal changes, regardless of the track marking parameter
setting (“T.Mark LSync” or “ T.Mark Off”).
z
You can mark track numbers even after recording has
finished
See “Dividing Tracks” on page 32.
Note
If you turn off the deck or disconnect the AC power cord, the
deck will store the last settings (“T.Mark LSync” or “ T.Mark Off”
and the trigger level) and apply them the next time you turn on
the deck.
Marking Track Numbers
While Recording (Track Marking)
You can mark track numbers either manually or
automatically while recording. By marking track
numbers at specific points, you can quickly locate the
points later or edit the MD easily.
MENU/NO
YES
./>
z
. >
m M
z x
X
H
Z
` / 1
+
–
+
–
Marking track numbers manually
(Manual Track Marking)
Press z at the point where you want to add a track
number while recording.
Marking track numbers automatically
(Automatic Track Marking)
When recording from a CD player or MD deck connected
to the DIGITAL (OPTICAL) IN1/2 connector, the deck
marks track numbers in the same sequence as the source.
When recording from other sources connected to the
DIGITAL (OPTICAL) IN1/2 connector or a source
connected to the LINE (ANALOG) IN jacks, do the
procedure below to mark track numbers automatically.
1 While the deck is stopped, press MENU/NO twice.
“Setup Menu” appears in the display.
2 Press ./> repeatedly until “T.Mark” appears,
then press YES.
3 Press ./> repeatedly to select the setting,
then press YES.
To Select
Turn on Automatic Track Marking T.Mark LSync (factory
setting)
Turn off Automatic Track Marking T.Mark Off