Filter
Top Products
6
6 For models with a voltage selector,
set VOLTAGE SELECTOR to
position of your local power line
voltage.
7 Connect the power cord to a wall
outlet.
The demonstration appears in the
display. When you press 1/u, the system
turns on and the demonstration
automatically ends.
If the supplied adapter on the plug does
not fit your wall outlet, detach it from
the plug (only for models equipped with
an adapter).
To connect optional components
See page 38.
To deactivate the demonstration
When you set the time (Step 3: Setting the
time), the demonstration is deactivated.
To activate/deactivate the demonstration
again, press DISPLAY (U.S.A., Canadian and
European models) or DEMO (STANDBY)
(other models) while the system is off.
Tip
You can reinforce the bass sound by connecting an
optional super woofer to the super woofer
connector.
To attach the speaker pads
Attach the supplied speaker pads to the
bottom of the speakers to stabilize the
speakers and prevent them from slipping.
Use the large speaker pads for the front
speakers, and the small speaker pads for the
center and rear speakers.
Inserting two size AA (R6)
batteries into the remote
Tip
With normal use, the batteries should last for about
six months. When the remote no longer operates
the system, replace both batteries with new ones.
Note
If you do not use the remote for a long period of
time, remove the batteries to avoid possible damage
from battery leakage.
When carrying this system
Do the following to protect the CD
mechanism.
1 Press CD (or FUNCTION on the remote
repeatedly) until “CD” appears in the
display.
2 Hold down ENTER and press 1/u so that
“LOCK” appears in the display.
Step 1: Hooking up the system
(continued)
VOLTAGE SELECTOR
220V
120V
230
240V
-
]
}
]
}