Filter
Top Products
Basic Operations
15
TUNED
STEREO
MHz
1 Press TUNER BAND repeatedly
until the band you want appears in
the display.
The bands you can receive vary
depending on the model you purchased.
Be sure to check which bands you can
receive.
Every time you press the button, the
band changes as follows:
2 band model:
FM ˜ AM
3 band model:
FM n MW n SW
or
FM n AM n UKV*
* “STEREO PLUS” is displayed when
you select UKV.
2 Turn the jog dial (or press = or
+ on the remote) to tune in the
desired preset station.
When only one station is preset, “ONE
PRESET” appears in the display.
n
n
To Do this
Turn off the radio Press 1/u (power).
Adjust the volume Turn VOLUME (or
press VOLUME +/– on
the remote).
To listen to non-preset radio
stations
Use manual or automatic tuning. For manual
tuning, press – or + repeatedly. For automatic
tuning, press and hold – or +.
Tips
•Pressing TUNER BAND when the power is off
automatically turns the power on and tunes to the
last received station (One Touch Play). When the
system is in the Power Saving Mode, the One
Touch Play function does not work.
•You can switch from another source to the radio
just by pressing TUNER BAND (Automatic Source
Selection).
•When an FM programme is noisy, press STEREO/
MONO so that “MONO” appears in the display.
There will be no stereo effect, but the reception
will improve. Press the button again to restore the
stereo effect.
•To improve broadcast reception, reorient the
supplied antennas.
Turn clockwise
(or press +
on the remote)
for higher
preset numbers.
Turn counter-
clockwise
(or press =
on the remote)
for lower preset
numbers.
Preset number
Frequency
≠ +