Sony MHC-NX3AV Stereo System User Manual


 
37
4 Set the time to start recording.
Press V or v to set the hour, then press
ENTER.
The minute indication starts flashing.
Press V or v to set the minute, then press
ENTER.
The hour indication flashes again.
5 Set the time to stop recording
following the above procedure.
The start time appears, followed by the
stop time, the recording source and the
radio station, then the original display
appears.
6 Insert a recordable tape into deck B.
7 Turn off the power.
When the recording starts, the volume
level is set to the minimum.
To check the setting
Press TIMER SELECT and press V or v to
select “REC”, then press ENTER. To change
the setting, start over from step 1.
To cancel the timer operation
Press TIMER SELECT and press V or v to
select “TIMER OFF”, then press ENTER.
Note
If the power is on at the preset time, the recording
will not be made.
REC
Timer-recording radio
programmes
To timer-record, you must preset the radio
station (see “Step 4: Presetting radio
stations”) and set the clock (see “Step 3:
Setting the time”) beforehand.
1 Tune in the preset radio station (see
“Listening to the radio” on page 14).
2 Press CLOCK/TIMER.
“SET (DAILY 1)” appears.
3 Press V or v to select “REC”, then
press ENTER.
“ON” appears and the hour digits flash
in the display.
)0P
+=p
·
·ª
·ª
·
p
V
v
bB
TIMER SELECT
2
3,4
3,4
7
REC