Filter
Top Products
Symptom Cause/Solution
The MD does not play
normally.
•
Stop playback when another play mode is selected. Then press and
hold the jog lever for two seconds or more.
•
When the repeat play is selected, press and hold the P-MODE/
button for two seconds or more until disappears.
The MD does not play from
the first track.
•
Playback with same MD starts from the point you last stopped
playing.
To start playback from the beginning of the same MD, press and hold
the jog lever on the remote for two seconds or more (or press and
hold the 5-way control key on the player toward for two
seconds or more). Or you can press
(stop) button and reinsert the
MD. Playback will start from the beginning because the player will
consider the MD to be a different one.
The playback sound skips.
•
When you use the player in a location that has a lot of vibration, place
the player where the vibration is the least.
•
A very short track, such as a brief narration or introduction, may
cause sound to skip.
•
Do not continuously give strong shocks to the player.
•
Do not use a dirty or scratched MD.
Noise is heard.
•
Move the player away from a television or other source of strong
magnetism which is causing interference.
Noise is briefly heard.
•
Because of the nature of the compression method used in the LP4
mode, noise may be output on very rare occasions during playback of
sound recorded in this mode.
•
Noise may be output when the cord of the headphones touches the
clothing, etc. This is not a malfunction.
During playback, the
operation lamp of the player
or the remote display does
not light up.
•
When “Power Mode” is set to “Power Save,” the lamp and display do
not light up except during operation. Select “Quick” or “Normal”
(page 31).
The group settings do not
function.
•
Insert an MD with group settings (page 25).
Troubleshooting (continued)
40
41
Additional
Information