Filter
Top Products
Symptom Cause/Solution
The player does not work or
works poorly.
•
Open the lid of the player, and then set the BUILT-IN BATTERY switch
located inside the right side of the player to ON.
•
Make sure that the HOLD function of the player or the remote is set
off (page 20).
•
Insert an MD if “NO DISC” is displayed.
•
End the setting operation using the remote if “MENU” is displayed.
•
Recharge the built-in battery if “LOW BATT” is displayed (page 14).
•
Insert a recorded MD if “BLANKDISC” is displayed.
•
Reinsert the MD if “READ ERR” or “TOC ERR” is displayed. If the
error message continues to be displayed, replace the MD with
another one.
•
When moisture condenses inside the player, remove the MD from the
player, set the BUILT-IN BATTERY switch to OFF, and leave the player
for several hours.
If you cannot solve the problems with the methods above, or if the
problems occurred due to the following causes, follow the steps below.
— While operating, the player received a mechanical shock.
— The player was affected by strong noise caused by too much static, an
abnormal power surge due to lightning, etc.
1 Set the BUILT-IN BATTERY switch to OFF.
2 Let the player sit for about 30 seconds.
3 Set the BUILT-IN BATTERY switch to ON and reconnect the player to a
power source.
There is no sound output from
the headphones.
•
Firmly plug the remote into the player and the headphones into the
remote.
The volume does not
increase.
•
Set “AVLS” to “Off” (page 30).
Continued on the next page
38
39
Additional
Information