27-GB
Using Auto Time Stamp to add
track marks while recording
After you set the time interval in step 4,
the recorder will begin adding a track
mark whenever the time interval has
elapsed. For example, if an Auto Time
Stamp interval of 5 minutes is set, and 8
minutes of recording has already been
done, then a track mark will be added at a
point equivalent to 13 minutes (8 + 5)
after the start of recording, and every 5
minutes thereafter.
If, however, the Auto Time Stamp interval
is longer than the elapsed recording time,
then a track mark will be added when the
Auto Time Stamp interval has elapsed.
For example, if the Auto Time Stamp
interval is set at 5 minutes, but only 3
minutes of recording has been done, then
a track mark will be added at the 5-minute
point after the start of the recording, and
every 5 minutes thereafter.
z
“ T” appears after the track number on the
recorder for track marks added by Auto Time
Stamp, and “T” appears after the time display
on the remote control.
Notes
• Automatic track marking by Auto Time Stamp
starts when you add a normal track mark to
the disc (i.e., by pressing T MARK or X,
etc.).
• The setting will be lost when the recording
stopped.
Adjusting the recording
level manually
(Manual recording)
When you record, the sound level is
adjusted automatically. If necessary, you
can set the level manually.
Note
Adjust the recording level while the recorder is
in standby mode. You cannot adjust it while
recording.
1 While holding down X, press and
slide REC to the right.
The recorder stands by for recording.
2 Press the jog lever (L), flip the lever
until “ RecVolume” flashes in the
display, and then press the lever
again.
3 Flip the jog lever (L) repeatedly until
“ ManualREC” flashes in the display,
and then press the lever.
To switch back to the automatic
control follow the procedure from
step 2 again, then flip the jog lever (L)
repeatedly until “ Auto REC” flashes
in the display, and then press the
lever.
4 Play the source.
REC
X
Jog lever (L)
ManualREC
continued