Filter
Top Products
CMT-DH7BT.GB.3-097-195-11(2)
54
GB
To erase all the pairing registration
information
1
Press FUNCTION +/
repeatedly
to select “BLUETOOTH” (or press
BLUETOOTH
on the unit).
When the system is connected with a
Bluetooth device (when the Bluetooth
device name or other information
appears in the system display), press
and hold BLUETOOTH OPR
on
the unit for about 2 seconds to put the
system in Bluetooth standby mode.
2
Press CLEAR
.
“Delete?” appears.
3
Press ENTER
.
“Complete!” appears and all the
pairing information is erased.
Note
In order to connect with a Bluetooth device
aer performing this operation, you must enter
the passcode again.
Playing music of a Bluetooth device
You can operate a Bluetooth device by
connecting the system and a Bluetooth
device using AVRCP. If the system is not
connected with a Bluetooth device using
AVRCP, “Not In Use” appears when you
operate the system.
1
Select the Bluetooth function.
Press FUNCTION +/
repeatedly
to select “BLUETOOTH” (or press
BLUETOOTH
on the unit).
2
Establish a connection from the
Bluetooth device.
For details about the operations of
the Bluetooth device, refer to the
operation manual supplied with your
Bluetooth device.
Once the connection is established,
the system display changes as follows:
“Connect” Name of the Bluetooth
device
3
Start playback.
Press
(or BLUETOOTH
on the unit).
Depending on the Bluetooth device,
you may need to start up the AV
soware of the Bluetooth device
beforehand.
4
Adjust the volume.
Press VOLUME +/
.
To check the address of a connected
Bluetooth device
Press DISPLAY
while the Bluetooth
device name appears in the system
display.
e Bluetooth device address appears for
8 seconds.