Filter
Top Products
15
CD
Programming the CD
tracks
— Program Play
You can make a program of up to 25 tracks
from all the CDs in the order you want them to
be played.
1 Turn FUNCTION to select “CD”, then
place a CD.
2 Press PLAY MODE repeatedly until
“PROGRAM” appears in the display.
3 Press one of the DISC 1–3 buttons to
select a CD.
To program all the tracks on a CD at once,
proceed to step 5 while “AL” appears in the
display.
4 Press . or > (CD) repeatedly until
the track you want appears in the
display.
5 Press ENTER (A/V amplifier or remote).
The track(s) is (are) programmed. The
program step number appears, followed by
the total playing time.
6 To program additional tracks, repeat
steps 3 to 5.
Skip step 3 to select tracks from the same
disc.
7 Press N (CD) (or CD H on the
remote).
To
Cancel Program Play
Check the program
Clear a track
Clear a specific track
Add a track to the
program when
playback is stopped
Tips
• The program you made remains in the system’s
memory even after it has been played back. Press
N (CD) to play the same program again.
• If “--.--” appears instead of the total playing time
during programming, this means:
– you have programmed a track number
which exceeds 20.
– the total playing time has exceeded 100 minutes.
Track
number
Disc tray
number
Total playing time
(including selected track)
Press
PLAY MODE repeatedly
when the playback is stopped
until “1 DISC” or “ALL
DISCS” appears in the display.
CHECK on the remote
repeatedly. After the last track,
“CHECK END” appears in the
display.
CLEAR on the remote when
playback is stopped. Each time
you press the button, a track is
cleared from the end of the
program.
CHECK on the remote
repeatedly until the track
number you want to clear
appears, then press CLEAR on
the remote.
1 Press one of the DISC 1–3
buttons to select a CD.
2 Press . or > (CD)
repeatedly to select the
track.
3 Press ENTER (A/V
amplifier or remote).