Filter
Top Products
10
Notice for carrying this system
Do the following to protect the CD
mechanism.
1 Turn on the system, then turn
FUNCTION to select “CD”.
Make sure that all discs are removed
from the unit.
2 While holding down EQ ON/OFF, press
?/1 until “LOCK” appears.
3 Release ?/1 first, then release EQ ON/
OFF.
4 Unplug the AC power cord.
Multi channel surround
setup
For the best possible surround sound, all
speakers should be the same distance from the
listening position (A). However, this unit lets
you to place the center speaker up to 1.5 meters
closer (B) and the rear speakers up to
4.5 meters closer (C) to the listening position.
The front speakers can be placed from 1.0 to
12.0 meters from the listening position (A).
You can place the rear speakers either behind
you or to the side, depending on the shape of
your room (etc.).
When placing rear speakers to your side
When placing rear speakers behind you
Note
Do not place the center speaker farther away from the
listening position than the front speakers.
Specifying the speaker
parameters
1 Press SET UP.
2 Press P or p repeatedly to select “SP.
SETUP”.
3 Press ENTER (A/V amplifier or remote).
4 Press P or p repeatedly to select the
parameter you want to adjust.
See the table on page 38 for the speaker
parameters.
5 Press O or o repeatedly to select the
setting you want.
The setting is stored.
6 Repeat steps 4 and 5 to set the speaker
parameters.
7 Press ENTER (A/V amplifier or remote).
x Center speaker selection (CENTER)
• If you connect a center speaker, select “YES”.
• If you do not connect a center speaker, select
“NO”. The sound of the center channel will be
output from the front speakers.
x Rear speaker selection (REAR)
• If you connect rear speakers, select “YES”.
• If you do not connect rear speakers, select
“NO”.
45°
90°
20°
A A
B
CC
45°
90°
20°
A A
B
CC
Inserting two size AA (R6) batteries
into the remote (continued)