Sony MHC-LX10000 Home Theater System User Manual


 
32
US
The system cannot play back the reverse side
of the tape in Deck A.
The system only can play back front side of the
tape in Deck A. This is not a malfunction.
When you turn . > clockwise or
counterclockwise (or press –. or >+ on
the remote), “Not in Use” flashes in the
display.
The system does not has AMS (Automatic Music
Sensor) function. This is not a malfunction.
If the system still does not
operate properly after performing
the above measures or other
troubles does not described
above occur, reset the system as
follows:
Use buttons on the unit for the operation.
1 Unplug the power cord.
2 Plug the power cord back in.
3 Press ?/1 to turn on the system.
4 Press x, ENTER and ?/1 at the same time.
The system is reset to the factory settings.
You should set the settings you made, such as
the preset stations, clock and timer.
One of the following messages may appear or
flash in the display during operation.
Disc
NO STEP
You have cleared all the steps you programmed.
OVER
You have reached the end of the disc while turning
and holding m M clockwise (or pressing M
on the remote) during playback or pause.
No Disc
There is no disc on the disc tray.
Push STOP!
You have pressed PLAY MODE on the remote
during playback.
Step Full!
You tried to program more than 25 steps.
Reading
The system is reading information of the disc. Some
buttons are not available.
Tape
No Tab
You cannot record the tape because the tab has been
removed from the tape.
No Tape
There is no tape in the tape deck.
Timer
OFF TIME NG!
The on time and off time of Play Timer or Timer
Recording is same.
SET CLOCK!
You pressed CLOCK/TIMER SELECT before the
clock is set.
SET TIMER!
You pressed CLOCK/TIMER SELECT before Play
Timer or Timer Recording is set.
PUSH SELECT!
You tried to set the clock or timer during timer
operation.
Others
Not in Use
You have pressed a button those operations is not
allowed or invalid at that time.
Messages