Sony MHC-LX10000 Home Theater System User Manual


 
30
US
The remote does not function.
Remove the obstacle between the remote and the
unit.
Move the remote closer to the unit.
Point the remote at the unit’s sensor.
Replace the batteries (R6/size AA).
Locate the unit away from the fluorescent light.
There is acoustic feedback.
Decrease the volume.
Move the microphone away from the speakers or
change the direction of the microphone.
The color irregularity on a TV screen persists.
Turn off the TV set once, then turn it on after 15
to 30 minutes. If the color irregularity still
persists, place the speakers farther away from the
TV set.
The sound from the component connected to
the VIDEO/MD (AUDIO) IN jacks is distorted.
If “VIDEO” appears in the display when you press
VIDEO/MD, switch to “MD” function (see “To
switch between the “VIDEO” and “MD”
function” on page 28).
Speakers
Sound comes from one channel or
unbalanced left and right volume.
Place the speakers as symmetrically as possible.
Check that the speakers are connected securely
and correctly.
The source being played back is monaural.
Sound lacks bass.
Check that the speaker’s + and – terminals are
connected correctly.
Disc player
The disc tray does not open and “LOCKED”
appears in the display.
Contact your nearest Sony dealer or local
authorized Sony service facility.
The disc tray does not close.
Load the disc correctly.
Always close the tray by pressing Z OPEN/
CLOSE. Trying to push the tray closed with your
fingers may cause problems with the system.
The disc does not eject.
You cannot eject the disc during CD Synchro
Recording. Press x to cancel the CD Synchro
Recording, then press Z OPEN/CLOSE to eject
the disc.
Consult your nearest Sony dealer.
Playback does not start.
Open the disc tray and check whether a disc is
loaded.
Wipe the disc clean (page 33).
Reload the disc.
Load the disc that this system can play back
(page 4).
Load the disc correctly.
Load the disc in the tray with the label side up.
Remove the disc and wipe away the moisture on
the disc, then leave the system turned on for a few
hours until the moisture evaporates.
Press nN (or N on the remote) to start
playback.
Disc access takes a longer time.
Set CD power manage function to “CD POWER
ON” (page 14).
The sound skips.
Wipe the disc clean (page 33).
Reload the disc.
Try moving the system to a place without
vibration (e.g., on top of a stable stand).
Try moving the speakers away from the unit, or
placing them on separate stands. When you listen
to a track with bass sounds at high volume, the
speaker vibration may cause the sound to skip.
Playback does not start from the first track.
The system is in Program Play or Shuffle Play
mode. Press PLAY MODE on the remote
repeatedly until “ALL DISCS”, “1 DISC” or
“ALBM” lights up in the display.