Filter
Top Products
11
EN
Recording on MDs
Recording Over Existing Tracks
Follow the procedure below to record over existing
material just as you would on an analog cassette tape.
1 Do Steps 1 to 5 in “Recording on an MD” on page
6.
2 Turn AMS (or press MD = or MD +) until
the number of the track to be recorded over
appears.
3 To record from the start of the track, continue
from Step 6 in “Recording on an MD” on page 7.
While “TRACK” flashes in the display
The deck is recording over an existing track, and stops
flashing when it reaches the end of the recorded
portion.
To record from the middle of the track
1 After Step 2 above, press fl (or MD ·) to start
playback.
2 Press fl (or MD P) where you want to start
recording.
3 Continue from Step 6 in “Recording on an MD” on
page 7.
Note
You cannot record from the middle of an existing track when
the “PROGRAM” or “SHUFFLE” is on.
Adjusting the Recording Level
When recording with INPUT at ANALOG and the
signal input through LINE (ANALOG) IN jacks, use
REC LEVEL to adjust the recording level before
starting recording.
You cannot adjust the recording level during digital
recording.
1 Do Steps 1 to 6 in “Recording on an MD” on
pages 6 and 7.
2 Play the portion of the program source with the
strongest signal level.
3 While monitoring the sound, turn REC LEVEL to
adjust the recording level so that the peak level
meters reach their highest point without turning
on the OVER indication. Occasional lighting of
“OVER” is acceptable.
4 Stop playing the program source.
5 To start recording, do the procedure starting from
Step 8 in “Recording on an MD” on page 7.
Without turning on the OVER indication
)0P
+
=
p
·
·ª
·ª
◊
·
)0P
+
=
p
√
MD = / MD +
= AMS +
•
•
•
•
•
•
•
•
•
•
•
p
·∏
•
•
•
•
r
)
0
§
=
+
•
•
•
•
•
•
•
•
•
•
•
p
·∏
•
•
•
•
•
•
•
r
)
0
§
=
+
REC LEVEL