Filter
Top Products
Additional Information
93
US
Rated impedance 3.0 ohms
Dimensions (approx.) 92 × 593 × 80 mm
(3
5
/8 × 23
3
/8 × 3
1
/4 inches)
(w/h/d)
280 × 1,200 × 280 mm
(11
1
/8 × 47
1
/4 × 11
1
/8
inches) (w/h/d) with stand
(long)
280 × 715 × 280 mm
(11
1
/8 × 28
1
/4 × 11
1
/8
inches) (w/h/d) with stand
(short)
Mass (approx.) 1.6 kg (3 lb 9 oz)
4.0 kg (8 lb 14 oz) with
stand (long)
3.5 kg (7 lb 12 oz) with
stand (short)
Center
Speaker system Closed, magnetically
shielded
Speaker unit 30 × 80 mm (1
3
/16 × 3
1
/4
inches) dia. cone type
Rated impedance 3.0 ohms
Dimensions (approx.) 380 × 47 × 61 mm
(15 × 1
7
/8 × 2
1
/2 inches)
(w/h/d)
Mass (approx.) 0.5 kg (1 lb 2 oz)
Subwoofer
Speaker system Bass reflex, magnetically
shielded
Speaker unit 200 mm (7
7
/8 inches) dia.
cone type
Rated impedance 1.5 ohms
Dimensions (approx.) 170 × 396 × 442 mm
(6
3
/4 × 15
5
/8 × 17
1
/2
inches) (w/h/d)
Mass (approx.) 8.1 kg (17 lb 14 oz)
General
Power requirements 120 V AC, 60 Hz
Power consumption On: 170 W
Standby: 0.3 W (at the
Power Saving mode)
Dimensions (approx.) 445 × 71 × 400 mm
(17
5
/8 × 2
7
/8 × 15
3
/4
inches) (w/h/d) incl.
projecting parts
Mass (approx.) 6.0 kg (13 lb 4 oz)
Surround amplifier (TA-WR4)
POWER OUTPUT AND
TOTAL HARMONIC
DISTORTION
(FTC Output Power): SL/SR: 84 W/ch 3 ohms at
160 - 20,000 Hz,
0.7 % THD
Surround mode (reference) RMS output power, 10 %
THD
140 W + 140 W
(with SS-TS55,
SS-TS56W)
Power requirements 120 V AC, 60 Hz
Power consumption 50 W
Dimensions (approx.) 280 × 60 × 280 mm
(11
1
/8 × 2
3
/8 × 11
1
/8
inches) (w/h/d)
Mass (approx.) 1.6 kg (3 lb 9 oz)
Design and specifications are subject to change
without notice.
Unpacking
• Speakers (5)
• Subwoofer (1)
• AM loop antenna (aerial) (1)
• FM wire antenna (aerial) (1)
• Speaker cords (5 m × 5, 3 m × 1)
(16.5 ft. × 5, 9.8 ft. × 1)
• Speaker cords (OPTION) (15 m × 2) (50 ft. × 2) *
• Video Cord (1)
• Remote Commander (remote) (1)
• R6 (size AA) batteries (2)
• Calibration mic (1)
• Foot pads (1 set)
• Posts (long × 4, short × 4)
• Bases (4)
• Pedestal (4)
• Screws with washer (short) (8)
• Screws with washer (long) (24)
• Surround amplifier (1)
• Speaker base (1)
• Spacers (8)
• Guide pins (4)
• Screws (8)
• IR transmitter (1)**
• IR receiver cord (1)**
• Operating Instructions
• Speaker and TV connections (card) (1)
* Use for connecting the surround speakers to the
system by the speaker cords.
**The IR receiver cord and IR transmitter are for this
system only. You cannot use a commercially
available extension cord.