Filter
Top Products
1-15
MVE-8000A
S1101 (A-4) : Monitor reset switch for the COM CPU-2
Used for maintenance purpose. Pressing this switch resets
the system while maintaining this unit through the COM
CPU-2 control terminal pin (CN703).
S1102 (A-4) : Modes setting switch for the COM
CPU-2
Sets the modes of the COM CPU-2, but this switch is
currently not in use. Factory setting is all OFF.
<LED on the CPU-DR module> : Main CPU
D10 (A-1) : RUN status LED
RUN status indication.
Lit when the CPU-DR module starts operating.
D12 (A-4) : CD (Card Detect) status LED
Lit when the CPU-DR module is inserted correctly into the
parent board.
D13 (A-1) :
++
++
+2.5 V
Indicates the status of the +2.5 V power that is generated
by the VCC (CORE) and supplied to the CPU-DR module.
Lit while the specified power is turned on.
D14, D15, D16, D17 (A-3) : STATUS1 to STATUS4
status LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
D18 (A-4) :
++
++
+3.3 V
Indicates the status of the VCC (I/O) power that is supplied
to the CPU-DR module.
Lit while the specified power is turned on.
D19 (A-4) : CORE status LED
Indicates the status of the VCC (CORE) power that is
supplied to the CPU-DR module.
Lit while the specified power is turned on.
<Switch on the CPU-DR module> : Main CPU
SW1 (A-1) : RESET switch
Pressing this switch resets the CPU-DR module.
n
In some machines in which the CPU-DR module is
installed, the system reset may be activated.
SW2 (A-2) : MODE switch
Used only for production in the assembly factory. All
switches are set to OFF for normal operation.
Factory setting is all OFF.
<LED on the CPU-DK module> : COM CPU-1
: COM CPU-2
DI1 (B-5) : CD (Card Detect) status LED
Lit when the CPU-DK module is inserted correctly to the
parent board.
DI2 (F-3) : RUN status LED
Lit when the CPU-DK module starts operating.
DI3 (F-3), DI6 (F-3), DI7 (F-3), DI8 (F-4) : STATUS1
to STATUS4 LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
DI4 (B-5) :
++
++
+3.3 V
Indicates the status of the VCC (CORE) and VCC (I/O)
powers that are supplied to the CPU-DK module.
Lit while the specified power is turned on.