Filter
Top Products
1-14
MVE-8000A
<Switch>
S101 (A-3) : Mode setting switch for the main CPU
Sets the modes of the main CPU, but this switch is current-
ly not in use. Factory setting is all OFF.
S102 (A-2) : Group ID setting switch for LAN
Sets the group ID for connecting LAN.
Factory setting and in standard use :
Bit 1 : ON
Bits 2 to 8 : OFF
S103 (A-2) : Unit ID setting switch for LAN
Sets the unit ID for connecting LAN. Do not change the
setting.
Factory setting :
Bit 1 : ON
Bits 2 to 8 : OFF
S104 (A-4) : Monitor reset switch for the main
CPU
Used for maintenance purpose. Pressing this switch resets
the system while maintaining this unit through the main
CPU control terminal pin (CN103).
S401 (A-1) : System reset switch
Pressing this switch activates the system-reset and the
system restarts.
S402 (A-1) : CA-CPU reset switch
Pressing this switch resets the CA-54CFC board.
S403 (B-1): Switch setting the number of the
power supply units
Sets the number of the power supply units that are required
for this unit. Do not change the setting.
Factory setting:
Bits 1 and 2: ON
Bits 3 and 4: OFF
S901 (A-4) : Monitor reset switch for the COM CPU-1
Used for maintenance purpose. Pressing this switch resets
the system while maintaining this unit through the COM
CPU-1 control terminal pin (CN503).
S902 (A-4) : Modes setting switch for the COM CPU-1
Sets the modes of the COM CPU-1, but this switch is
currently not in use. Factory setting is all OFF.
D602 (A-2) : PLL LOCK status LED
REF IN signal format status indication.
Lit when the REF IN signal matches with the switcher
format setup.
D701 (A-2) : SBUS RX status LED
S-BUS reception status indication.
Lit while the data reception is in progress.
D704 (A-2) : SBUS TX status LED
S-BUS transmission status indication.
Lit while the data transmission is in progress.
D901 (A-4), D902, D903, D904 (A-5) : COM CPU-1
status LED
COM CPU-1 status indication.
D1001 (A-2) : COM1 100 status LED
COM CPU-1 Ethernet communication speed status
indication.
Lit : 100 Mb/s
Not lit : 10 Mb/s
D1002 (A-2) : COM1 ACT status LED
COM CPU-1 Ethernet communication status indication.
Lit while data transmission or reception is in progress.
D1101, D1102, D1103, D1104 (A-5) : COM CPU-2
status LED
COM CPU-2 status indication.
D1201 (A-2) : COM2 ACT status LED
COM CPU-2 Ethernet communication status indication.
Lit while data send or receive is in progress.
D1202 (A-2) : COM2 100 status LED
COM CPU-2 Ethernet communication speed status
indication.
Lit : 100 Mb/s
Not lit : 10 Mb/s
D1303 (A-2) :
++
++
+5 V
+5 V power supply status indication.
Lit when the +5 V power is supplied.
ND901, ND902 (A-4) : COM CPU-1 status LED
COM CPU-1 status indication.
ND1101, ND1102 (A-4) : COM CPU-2 status LED
COM CPU-2 status indication.