Filter
Top Products
1-10
MVE-8000A
B4 x 10
2U
B4 x 10
31.75
31.75
Unit : mm
5. Tighten the screws (B4 x 6 : two screws each on the
right and left) for adjusting the length of the adaptor
completely (the screws that were loosened in step 2).
6. Align the groove of the rack tool at the side of the
equipment with the rail, and slide the equipment to the
rear.
n
The rack tools are hooked on the rails as shown below.
7. Remove the front door assembly.
(Refer to Section 1-4-1.)
8. Fix the rack angles in the rack using the specified
screws.
9. Install the front door assembly to the equipment.
B5 x 12
B5 x 12
3. Loosen the screws on the rear of the right and left
adaptors and adjust the length of the adaptor according
to the depth of the rack.
(The illustration below shows the left adaptor.)
n
Maximum depth of adaptor :750 mm
Minimum depth of adaptor : 595 mm
4. Attach the right and left adaptors to the rack complete-
ly using the specified six screws.
(The illustration below shows the left adaptor.)
B4 x 6
B4 x 6
Adaptor
Portion of
the rail
Rack tool
Rack tool
Rail
Rail