Filter
Top Products
Getting Started
9
GB
Notes
• When inserting the speaker cord plugs into the
SPEAKER terminals on the unit, press in the plugs
all the way until they click. When unplugging the
speaker cords, press the protrusions on the plugs and
pull out the plugs.
• Keep the speaker cords away from the antennas to
prevent noise.
• Do not place the surround speakers on top of a TV.
This may cause distortion of the colors in the TV
screen.
• Be sure to connect both left and right surround
speakers. Otherwise, the sound will not be heard.
Tip
When positioning the front speakers higher than floor
level, using the speaker stand WS-MC1 (not supplied)
is convenient.
2 Connect the FM and AM antennas.
Set up the AM loop antenna, then connect
it.
3 Connect the t INPUT jack of your TV
to the T LINE-TV jack on the unit with
the SCART cord (not supplied).
When you connect using the SCART cord,
check that the TV conforms to S video or
RGB signals. If the TV conforms to
S video, change the input mode of the TV to
RGB signals. Refer to the operating
instructions supplied with the TV to be
connected.
When using a TV
Turn on the TV and select the video input so that you
can view the pictures from this system.
When connecting a video deck
Connect the TV and the video deck using video and
audio cords (not supplied) as shown below.
If you connect a video deck between this system and the
TV, you may experience video leakage when watching
the video signal from this system. Do not connect a
video deck between this system and the TV.
Note
Do not place the TV on this system.
Tip
To listen to TV, press FUNCTION repeatedly to select
“TV”.
Extend the FM lead antenna horizontally
AM loop antenna
TV
Video deck System
Do not connect
directly.
continued