Filter
Top Products
Tuner
39
GB
Other operations
Tips
• The preset stations are retained for about a day even
if you disconnect the mains lead or if a power failure
occurs.
• You can label the preset stations “Labelling the
preset stations” (page 40).
• To improve the reception, adjust the supplied
antennas or connect an external antenna.
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 38).
1 Press TUNER BAND repeatedly (or
move TUNER lever on the unit to FM or
AM) to select “FM” or “AM”.
2 Press TUNING MODE repeatedly until
“PRESET” appears.
3 Press + or – (or move TUNER lever on
the unit to + or –) repeatedly to select
the desired preset station.
* The station name appears only if you have
labelled the station (see “Labelling the preset
stations” on page 40).
To select the desired preset
number using the number buttons
Press number buttons instead of performing
step 3. To enter preset number 10 or higher,
press >10 and the corresponding number
buttons. To enter 0, press 10/0.
In addition, you can select a preset number even
when the tuning mode is other than PRESET by
selecting + or – with the TUNER lever on the
unit.
To Do this
Tune in a station
with a weak signal
Follow the procedure described
in “Manual tuning preset”.
Set another station
to the existing
preset number
Start over from step 1. After
step 5, press + or – (or move
TUNER lever on the unit to + or
–) repeatedly to select the preset
number you want to store the
other station.
Listening to the radio
Frequency*Preset number
continued