Filter
Top Products
62
GB
Notes on discs
• Before playing, clean the disc with a cleaning cloth.
Wipe the disc from the center out.
• Do not use solvents such as benzine, thinner,
commercially available cleaners or anti-static spray
intended for vinyl LPs.
• Do not expose the disc to direct sunlight or heat
sources such as hot air ducts, nor leave it in a car
parked in direct sunlight.
• Do not use discs encircled with a protection ring.
This may cause a malfunction to the system.
• When using discs that have glue or similar tacky
substance on the label side of the disc or that used a
special ink when the label was printed, there is a
chance that the disc or label may become attached to
parts inside this unit. When this occurs, it may not be
possible to remove the disc, and may also cause this
unit to malfunction. Be sure to check that the label
side of the disc is not sticky before using.
The following types of disc should not be used:
– Rental or used discs with attached seals where the
glue extends beyond the seal. The perimeter of the
seal on the disc is tacky.
– Discs that have labels printed using a special ink
that feels tacky when touched.
• Discs with non-standard shapes (e.g., heart, square,
star) cannot be played on this unit. Attempting to do
so may damage the unit. Do not use such discs.
Cleaning the cabinet
Clean the cabinet, panel and controls with a soft cloth
slightly moistened with mild detergent solution. Do not
use any type of abrasive pad, scouring powder or
solvent such as thinner, benzine or alcohol.
Disc cleaning
Do not use a commercially available CD/DVD lens
cleaning disc with this system, as this may result in
malfunction.
Main unit (HCD-SE5)
Amplifier section
The following measured at AC 230 V, 50/60 Hz
DIN power output (rated): 20 + 20 W
(6 ohms at 1 kHz, DIN)
Continuous RMS power output (reference)
Front speaker: 25 + 25 watts
(6 ohms at 1 kHz, 10%
THD)
Center speaker: 25 watts
(8 ohms at 1 kHz, 10%
THD)
Surround speaker: 25 + 25 watts
(6 ohms at 1 kHz, 10%
THD)
Subwoofer: 50 watts
(3 ohms at 1 kHz, 10%
THD)
Music power output (reference):
40 + 40 W
Inputs
MD/TAPE IN (phono jack):
Voltage 250 mV,
impedance 47 kilohms
VIDEO/SAT IN (phono jacks):
Voltage 450/250 mV,
impedance 47 kilohms
VIDEO/SAT IN VIDEO (phono jack):
1 Vp-p, 75 ohms
MD DIGITAL IN OPTICAL:
Supported sampling
frequencies: 32 kHz,
44.1 kHz and 48 kHz
VIDEO/SAT DIGITAL IN OPTICAL:
Supported sampling
frequencies: 32 kHz,
44.1 kHz and 48 kHz
Specifications