Filter
Top Products
5
Getting Started
3 (CMT-MD1 only)
Attach the speakers.
Facing the front of the system, attach
the speaker connected to the
SPEAKER R terminals onto the right
side of the system and the speaker
connected to the SPEAKER L
terminals onto the left side of the
system.
Afterwards, push down on the
speakers to make sure they are
securely fastened to the system.
3 Connect the FM/AM antennas.
Set up the AM loop antenna, then
connect it.
2 (CMT-MD1 only)
Fasten the four screws to both sides of
the system.
5 After making sure that the cords are
correctly and securely connected,
reinstall the rear cover.
Put the wires through the hole at the
bottom of the rear cover.
4 For models with a voltage selector,
set VOLTAGE SELECTOR to the
position of your local power line
voltage.
VOLTAGE SELECTOR
110-120V
220-240V
continued
Jack type A
Jack type B
FM
75Ω
AM
y
COAXIAL
LOOP
ANTENNA
AM loop
antenna
Extend the FM
wire antenna
horizontally
FM
75Ω
AM
y
COAXIAL
LOOP
ANTENNA
AM loop
antenna
Extend the FM
wire antenna
horizontally