Filter
Top Products
24
US
Setting up the Main Unit
Adjusting the source input offset
– SOURCE INPUT OFFSET
You can keep the volume balance among source
components by taking an average of the output level from
each source component.
1 Turn off the power.
2 Press and hold ZONE + and ALL ZONE MUTING
simultaneously, and then turn on the power.
“SOURCE OFFSET” appears in the display window
for a few seconds.
3 Press the R cursor or r cursor repeatedly to select a
source number.
Each time you press the R cursor or r cursor, the
display window changes cyclically as shown below.
SOURCE OFFSET (Appears for a few seconds)
r
t SOURCE 1 R r
Y
SOURCE 2 R r
t SOURCE 8 R r
4 Press ENTER.
The display window displays the OFFSET settings.
5 Press the R cursor or r cursor to adjust the offset.
Each time you press the R cursor or r cursor, the
display window changes cyclically as shown below.
t OFFSET 0dB
R r
OFFSET -1dB R r
OFFSET -2dB R r
OFFSET -3dB R r
OFFSET -4dB R r
t OFFSET -5dB R r
6 Press ENTER when you want to adjust the offset
for other source components.
The step goes back to step 3.
7 Press CANCEL when you have finished.
The display window returns to the NORMAL mode.
Note
In a zone where SOURCE INPUT OFFSET is ON, the actual
volume level is lower than the displayed volume level.
…
Locking the settings – SETUP LOCK
You can lock in the settings under which have been
entered into the Main Unit.
1 Turn off the power.
2 Press and hold SOURCE SELECT + and BACK
simultaneously, and then turn on the power.
“SETUP LOCK” appears for a few seconds, then the
display window displays the SETUP LOCK window.
3 Press the R cursor or r cursor to turn SETUP LOCK
on or off.
The display window changes as follows:
SETUP LOCK (Appears for a few seconds)
r
LOCK [OFF]
R r
LOCK [ON] R r
4 Press ENTER when you have finished.
The display window returns to the NORMAL mode.
Notes
• The following are the preferences that can be locked in in
the SETUP LOCK mode.
- All settings in the LEARN mode.
- All settings in the SETUP mode.
- Settings for the Disc Search.
- The adjustment of SOURCE OFFSET.
- All Clear.
• When you select settings that cannot be changed,
“LOCKED!” appears for a few seconds, then the display
window returns to the NORMAL mode.
Customizing the Main Unit – INSTALLATION Mode