Filter
Top Products
1-18
DFS-700/700P
Chapter 3 Basic Operation
3-8
Chapter 3 Basic Operation
Demonstration
The DFS-700/700P is equipped with a demonstration function, which
automatically plays back one hundred effects stored in ROM in the
processor unit.
The effects (which by factory default are snapshots 0 to 99) have been
chosen to demonstrate the features of the DFS-700/700P as effectively as
possible.
For maximum effect, the demonstration function uses the signals
connected to VIDEO INPUT connectors 1 and 2, and the internal video
signal.
Buttons used for the demonstration
To start the demonstration
In the pattern/numeric keypad, hold down buttons 1 and 9, and press the
AUTO TRANS button.
The one hundred effects stored in ROM are played back continuously, and
repeated until you press the AUTO TRANS button once more. During the
demonstration, the buttons on the pattern/numeric keypad light in turn in
the clockwise direction.
During the demonstration, the control panel does not accept any operations
other than pressing the AUTO TRANS button.
Demonstration with user-registered snapshots
It is also possible to have a demonstration with user-registered snapshots.
In this case, hold down buttons 3 and 7 in the pattern/numeric keypad, and
press the AUTO TRANS button. During the demonstration, the buttons on
the pattern/numeric keypad light in turn in the counterclockwise direction.
LAST X
INS
RST
TITLE
12
EDITOR LUM LUM LUM
DSK EDGE
TRAIL
SHADOW
GPI CRK CRK BORDERBEVELD
EDGE
SET UP MASK MASK MASK SOFT
SHIFT CCR LIGHTING BORDERMATTES
LOCATION
LEARNEDIT
RECALL
HOLD
INPUT
INITIAL
PATTERN
ADJ
PAGE
F1 F2 F3 F4 F5
USER PGM
STATUS EDIT
SNAP SHOT
SET
PATTERN NUMBER
EFFECT
DSK
FTB
SET
TRANS RATE
789
456
123
0
DOWN UP
ENTER
FADE
TO
BLACK
P IN P
DSK
DEL
N/R REV DSK PVWDIRECT
RECALL
DIRECT
PATTERN
CCR TITLE 1
SOURCE
TITLE 2
SOURCE
DSK
FILL
SUPER BGFRGD 2MEMORYFRAME FREEZ MIX EFFECT
BACKGROUND
BLACK MEMORY INT
VIDEO
TITLE
12345678
CUT
AUTO
TRANS
AUXILIARY
BLACK
MEMORY
INT
VIDEO
12345678
FOREGROUND
BLACK
MEMORY
INT
VIDEO
12345678
PATTERN/KEY PAD
Pattern/numeric
keypad
AUTO TRANS button
DME Switcher Introduction
Chapter 3 Basic Operation
Chapter 3 Basic Operation
3-9
To end the demonstration
Press the AUTO TRANS button once more.
The demonstration ends, and the control panel settings are those of the last
effect in the demonstration.