Filter
Top Products
58
US
• You cannot use z individually. z is used with
H, X, or x. When learning, press H, X, or
x while pressing z.
9 Point the remotes at each other.
10 Press the button on the other remote
that you want to program to the
supplied remote.
Note
• If you do not press a button for more than 10
seconds after Step 8, the supplied remote status
returns to its status after Step 7. Re-perform
from Step 8.
11 Repeat Steps 8 to 10 to continue
programming more buttons.
If you successfully program the remote
code, the BD operation mode button will
flash twice slowly. If the setting is
unsuccessful, the TV or STB operation
mode button will flash five times quickly.
Note
• You can exit from Learning mode by pressing the TV
or STB operation mode button (whichever button is
flashing).
• If you do not press a button to be programmed during
Learning mode for more than 1 minute, the remote
exits from Learning mode.
To clear a programmed remote
code
1 Follow Steps 1 to 7 of “Programming
the remote code from another remote
(Learning mode).”
2 Press [/1 for more than 1 second.
The TV or STB operation mode button
flashes twice.
3 Press the button on the supplied
remote for which you want to clear the
remote code.
If you successfully clear the remote code,
the BD operation mode button will flash
twice slowly. If the clearing is
unsuccessful, the BD operation mode
button will flash five times quickly.
4 Repeat Step 3 to continue clearing
more buttons.
Note
• When you clear the programmed remote code, the
button’s operation returns to the default setting.
1 Press and hold AV ?/1 first, then press
VOL –, then press CH –.
The BD, TV, and STB operation buttons
light up.
2 Release all buttons.
The BD, TV, and STB operation mode
buttons turn off and all the added remote
codes are cleared. The remote returns to its
default settings.
Saving Power in Standby
Mode
Check that the following settings are made:
– [Control for HDMI] in [HDMI Settings] is set
to [Off] (page 50).
– [Standby] in [S-AIR Settings] is set to [Off]
(page 47).
– [Quick Start Mode] is set to [Off] (page 64).
Clearing all the preset and
programmed remote codes
from the remote’s memory