Filter
Top Products
D Select the aspect ratio that matches your TV,
and press ENTER.
<_ If youhavea widescreenTVora 4:3standardTV
with a wide screen mode
Select "16:9" (page 45).
* If you havea 4:3 standardTV
Select "4:3" (paq,e 4_5),
1_ Select "Finish Setup," and press ENTER.
"_° Hints
• If 3ou wmlt to reset these settings to their factory defaults, see
"Resettiug the Player" (page 53).
• You can re-run "Easy Setup" from "Options" Setup (page ,52).
The following settings and adjustments are necessary when your
connection applies.
Forvideoconnection
*When usingtheCOMPONENTVIDEOOUTjacks
(Pattern (_ _agr' I0)
• Select the video output resolution t_r your TV by pressing
VIDEO FORMAT (page 46).
*When usingtheHDMIOUTjack
(Pattern (_) -page I l)
• Select the video output resolution for your TV by pressing
VIDEO FORMAT (page 46).
• Select the type of video output from the HDMI OUT jack in
"YCbCr/RGBPC (HDMI)" of "Video Setup" (page 45).
Foraudioconnection
*When usingtheDIGITALOUT(OPTICALor COAXIAL)jack
(Connection t_, _[P, _ -[)aj,,, ]3 to ]5)
• Set "Dolby Digital" and "DTS" in "Audio Setup" (page 47)
according to your AV amplifier's (receiver's) decoder.
*When usingtheHDMIOUTjack
(HDMI connection of 1_, tl_ _age 15)
• Set "Dolby Digital" and "DTS" in "Audio Setup" (page 47)
according to your AV amplifier's (receiver's) decoder.
• Select the audio output method from the HDMI OUT jack in
"Audio (HDMI)" of "Audio Setup" (page 47).
*When usingtheAUDIOOUT(L/R)jacks
(Connection _ _)age 14)
• Set "DTS Dowumix" to "Lt/Rt" in "Audio Setup" (page 47).
*When usingthe5.1CHOUTPUTjacks
(Connection _ -page 14)
• Set "Audio Output Mode" to "5.1 Channel" in "Speakers"
Setup (page 51), and adjust the "Speaker Setup" setting for
your system.
• If you counect a component that does not conform tothe selected audio
signal, a loud noise/or no sound) will come out from the speakers.
which could damage your ears or speakers.
• If you connect using the HDMI OUT jack or COMPONENT VIDEO
OUT jacks and the picture does not appear clearly, the connected
display device may not be compatible with the progressive signals. In
this case. connect the display device to the S VIDEO.jack or the
VIDEO jack (pattern (_) or (_) see page lO), re-run the "Easy Setup"
from the "Options" Setup lpage 52), and select "S-Vkleo/Video only"
in step 6 (page lb,').Also. check the above items again to see if any
additional atliustment is required.
lg