Filter
Top Products
59
GB
Additional Information
Remote control
The remote does not function.
• For receiver operation, you can only use
the DISPLAY button when the TUNER
input is selected.
• Point the remote at the remote sensor on
the receiver.
• Remove any obstacles in the path between
the remote and the receiver.
• Replace all the batteries in the remote with
new ones, if they are weak.
• Make sure you select the correct input on
the remote.
Others
The ACTIVE STANDBY lamp is
flashing.
• The receiver is in protection mode. Turn
off the receiver and turn it on again.
Error messages
If an error message appears while you perform
Auto Calibration, see “When error codes
appear” (page 25) to solve the problem.
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver’s memory may remedy
the problem (page 22). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the receiver’s memory
To clear See
All memorized settings page 22