Filter
Top Products
47
GB
“BRAVIA” Sync Features
Enjoying the TV sound
from the speakers
connected to the receiver
(System Audio Control)
You can enjoy the TV sound from the speakers
connected to the receiver by a simple
operation.
You can operate System Audio Control
function using the TV menu. For details, refer
to the operating instructions of the TV.
When System Audio Control function is
turned on, the receiver will turns on and
switches to the appropriate input
automatically.
TV sound is output from the speakers
connected to the receiver, and the volume of
the TV is minimized simultaneously.
You can use the System Audio Control
function as follows.
• If you turn on the receiver while the TV is
turned on, the System Audio Control
function will automatically be set to on and
the TV sound will output from the speakers
connected to the receiver. However, if you
turn off the receiver, the sound will output
from the TV speakers.
• You can adjust the receiver’s volume when
you adjust the TV volume.
Notes
•If System Audio Control does not function
according to your TV setting, refer to the operating
instructions of the TV.
• When you connect a TV that does not have System
Audio Control function, the System Audio Control
function does not work.
•If the TV is turned on before turning on the
receiver, the TV sound will not be output for a
moment.
When the System Audio Control function is
active, and the output method changes from
the TV speaker to the speakers connected to
the receiver automatically, loud sound may be
output depending on the volume level of the
receiver. You can prevent this by limiting the
maximum volume level.
1 Press AMP MENU.
2 Press v/V repeatedly until “SET
HDMI” appears, then press
or b.
3 Press v/V repeatedly until “VOL
LIM” appears, then press or
b.
4 Press v/V repeatedly to select
the maximum volume level you
want.
The maximum volume level changes as
follows:
LIM MAX y LIM 39 y LIM 38 y
...... y LIM 2 y LIM 1 y LIM MIN
5 Press AMP MENU.
The AMP menu turns off.
Notes
•This function is available only when the Control
for HDMI function is set to on.
•This function is not available when the output
method changes from the speakers connected to the
receiver to the TV speaker.
Tips
•Sony recommends that you set the maximum
volume level to a little lower than the volume you
usually listen to.
•Regardless of the maximum volume level you set,
the MASTER VOLUME on the receiver and the
2 +/– button of the remote are operable.
•If you do not want to limit the maximum volume
level, select “MAX”.
Using the Volume Limit function