Filter
Top Products
6
Transporter Owner’s Guide
SLIM DEVICES
Connecting Transporter
1. Connect an output from the Transporter to your stereo amplifier, preamp, or receiver with the
appropriate interconnect.
The most common connection uses the unbalanced analog output red and white RCA connectors
to connect to a line-level input, such as a CD or TAPE input. (Note: Transporter’s outputs are not
compatible with PHONO inputs.) More details about Transporter’s audio connections are available in
the Audio Connections section.
2. If you are using an ethernet network connection with your Transporter, connect an ethernet cable from
your hub or switch to Transporter. Otherwise, screw the included wireless antennae to the two gold
antenna connectors on Transporter.
3. Put the two AA batteries into the remote control.
4. Connect the included power cable to Transporter and plug it in.
You can leave Transporter plugged in all the time. When not in use, it enters standby mode and dims
the display. You can also dim the display by pressing the BRIGHTNESS button on the remote or front
panel.
Balanced Optical Coax BNC AES/EBU Word Infrared Ethernet RS-232 AC Power
Analog S/PDIF S/PDIF Balanced Clock Input Output Serial
Outputs Input
Digital Outputs
Digital Inputs
Unbalanced Analog Optical Coax BNC AES/EBU
Outputs TOSLINK S/PDIF S/PDIF Balanced Antenna Connectors