Filter
Top Products
7
SUB
WOOFER
VIDEO 3
VIDEO 4
CD
TAPE/MD
MULTIROOM
VIDEO 3
VIDEO 4
VIDEO 2
VIDEO 3
VIDEO 4
VIDEO 2
VIDEO 3
Y
C
B
C
R
Y
C
B
C
R
VIDEO 2
VIDEO 3
VIDEO 4
DIGI
-
LINK
AC INPUT
120V~60Hz
4A
SWITCHED
120V~60Hz
TOTAL 100W 1A MAX
AC OUTLETS
MODEL NO. R
-
956
AUDIO/VIDEO RECEIVER
SER. NO
MADE IN KOREA
DESIGNED IN USA
C
E85649
29Z3
LISTED
AUDIO EQUIPMENT
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)this device must accept any interference received,
including interference that may cause undesired operation.
Manufactured under license from Digital Theater Systems, Inc.
US Pat. No. 5,451,942 and other world-wide patents issues and pending.
“DTS” and “DTS Digital Surrou emarks of Digital Theater
Systems, Inc.
©1996 Digital Theater Systems, Inc. All rights reserved.
Manufactured under license from Dolby Laboratories. “Dolby”, “Pro Logic”
and the double-D symbol are trademarks of Dolby Laboratories.
Confidential Unpublished Works.
©1992-1997 Dolby Laboratories, Inc.
All rights reserved.
6.1-CH
DIRECT
INPUT
FRONT
REAR
REAR
CENTER
FRONT
CENTER
PHONO
CD
AUX
VIDEO 1
VIDEO 2
AM
LOOP
VIDEO 2
VIDEO 1
MONITOR
FRONT
SPEAKERS
(8
Ω
)
REAR
SPEAKERS
(8
Ω
)
REAR
CENTER
SPEAKER
(8
Ω
)
FRONT
CENTER
SPEAKER
(8
Ω
)
ANTENNA
VIDEO 1
6.1 CH
S
-
VIDEO
6.1 CH
VIDEO 1
IN
IN IN
OUT
VIDEO
OUT
TAPE
MON.
VIDEO 1
ROOM 2
GND
VIDEO 1
R R
OUT
OPTICAL
COXIAL
DIGITAL
IN
PRE
OUT
FRONT
CENTER
L R
L R
L R
SUB
WOOFER
FRONT
REAR
REAR
CENTER
TAPE
MON.
L R
LR
LR
ROOM 2
VIDEO 1
OUT
REC
REC
MONITOR
Y
C
B
C
R
MONITOR
COMPONENT
" is a trademark of SRS Labs, Inc."
“
is a trademark
of SRS Labs,
Inc.”
• The speaker terminals are designed to accept either
bare wire or banana plugs.
• If using bare wire, take care to not allow the + and -
wires to touch or short.
• Connect the speaker wires firmly and correctly
according to the channel and position. Observe the
proper polarity (+ and -).
• To reproduce the center rear signal in 6.1 channel
material, connect a rear center speaker. Otherwise the
center rear speaker is not necessary.
• This receiver is designed for use with speakers rated at
8 ohms impedance or above.
■ CONNECTING SPEAKERS
• Use these jacks to connect the corresponding analog
outputs of an external 6.1(or 5.1) channel decoder or to a
DVD player with 6.1(or 5.1) channel outputs.
• In the case of a 5.1 channel decoder or DVD player, do
not make a connection to the rear center input. (For
more details, please see the operator's manual of the
component to be connected.)
6.1 CH decoder
REAR CH OUT
CENTER CH OUT
FRONT CH OUT
SUBWOOFER CH OUT
■ CONNECTING 6.1 CH DIRECT INPUTS
■ CONNECTING SYSTEM CONTROL
• Use these jacks when adding additional amplifiers.
• Connect the PRE OUT jacks to the powered speakers or the power
amplifiers connected to speakers respectively.
• To emphasize the deep bass sounds, connect a powered subwoofer.
• Only in case of enjoying 6.1 channels of digital audio, make the rear
center connections between the audio equipment.
Front speakers
Power amplifier
Rear speakers
Power amplifier
Rear center
speaker
Front center
speaker
Powered subwoofer
■ PRE OUT connections
Power amplifier
SUB
WOOFER
FRONT
REAR
REAR
CENTER
FRONT
CENTER
6.1-CH
DIRECT
INPUT
FRONT
SPEAKERS
(8
Ω
)
REAR
SPEAKERS
(8
Ω
)
REAR
CENTER
SPEAKER
(8
Ω
)
FRONT
CENTER
SPEAKER
(8
Ω
)
Front right
Front left
Rear
left
Rear
right
Rear
center
Front
center
DIGI
-
LINK
System
control
cord
Sherwood component
with DIGI LINK II or III
CD player
Tape deck
Graphic equalizer
DVD player
• Connect this jack to the DIGI LINK jack of the external
Sherwood component that uses the DIGI LINK II or III
remote control system.
PRE
OUT
FRONT
CENTER
L R
LR
LR
SUB
WOOFER
FRONT
REAR
REAR
CENTER
L R
ENGLISH