Sherwood R-956 Stereo Receiver User Manual


 
15
Operate the selected component for
playback.
5
Enter the tone mode.
7
Select the digital or the analog input
connected as desired.
4
Each time the MULTI CONTROL knob is rotated,
the tone mode changes as follows:
DIRECT ON: When listening to a pure program
source without the tone effect.
DIRECT OFF: When adjusting the tone for your
taste.
When “DIRECT ON” is selected.
“DIRECT” lights up, meaning the tone direct
function is activated and the sound that bypasses the
tone circuitry will be heard.
To cancel the tone direct function, select “DIRECT
OFF” performing the above steps 7 and 8.
When “DIRECT OFF” is selected.
1) Select the tone mode as desired.
Each time this button is pressed, the mode changes
as follows;
BASS TREBLE DIRECT OFF
2) At the desired tone, adjust as desired.
In general, we recommend the bass and the treble to
be set to 0(flat) level.
To complete tone adjustment, repeat the above steps
1) and 2).
Notes:
If the tone display disappears, start from the step 7
again.
Extreme settings of the tone controls at high volume
may damage your speakers.
In DTS or Dolby Digital modes, the tone controls
cannot be adjusted and the tone direct function is
activated automatically .
“DIRECT ON” or “DIRECT OFF” is shown for 5
seconds.
To play back the program sources in surround
sound, refer to “ENJOYING SURROUND
SOUND” on page 19.
Adjust the (overall) volume.
6
Select the tone mode as desired.
8
When CD, TAPE MON or VIDEO 1~
VIDEO 4 is selected
Adjusting the tone (bass and treble)
Each time this button is pressed, the corresponding
input is selected as follows;
DIGITAL ANALOG
To listen to DTS or Dolby Digital program sources
in the 2-CH downmix mode (the stereo mode), the
digital input must be selected. (For details, refer to
“Downmixing into 2 front channels” on page 22.)
When PHONO, TUNER, VIDEO 5 or AUX is
selected as an input source, the analog input is
selected automatically.
Note:
When the selected digital input is not connected or
has no sound, “DIGITAL” flickers indicating the
lack of sound. (refer to “ENJOYING SURROUND
SOUND” on page 19.)
ENGLISH
DIGITAL/ANALOG
TONE MODE
TONE MODE
MULTI CONTROL
MULTI CONTROL
MASTER VOLUME
DOWN
UP
S
E
T
U
P
AUD
SAT
VOL
VID 4
S
E
T
U
P
P.SCAN
VOL
SLEEP
CH LEVL
HOME THEATER MASTER
RNC-30
PWR
ENTER
PHONO CD TUNER
TAPE MON
T2 MONVID SEL VID 2 VID 3
VID 4 AUX ROOM 2SYS DISP
AUD CD DVD AUX
TV VCR CBLSAT
1 2 3
4 5 6
7 8 9
MUTE
0
CH SEL
T.TONE
D.TIME D.ADJ
STEREOAUTO
6.1CH INDSP MODE
OSD
or
VOL