Sherwood R-903 Stereo Receiver User Manual


 
ENGLISH
• Be sure to connect speakers firmly and correctly according
to the channel(left and right) and the polarity(+ and -). If the
connections are faulty, no sound will be heard from the
speakers, and if the polarity of the speaker connection is
incorrect, the sound will be unnatural and lack bass.
• For installing the speakers, refer to “Speaker placement” on
page 18.
• After installing the speakers, first adjust the speaker settings
according to your environment and speaker layout.(For
details, refer to “Adjusting the speaker settings” on page
19.)
Caution :
• Be sure to use the speakers with the impedance of 6 ohms
or above.
• Do not let the bare speaker wires touch each other or any
metal part of this unit. This could damage this unit and/or
the speakers.
8
5. CONNECTING 7 CH DIRECT INPUTS 7. CONNECTING SPEAKERS
8. AC INPUT CORD
6. SUBWOOFER PRE OUT connection
SUB
-
WOOFER
OUT
Subwoofer
FRONT
SPEAKERS(6 )
SURROUND
SPEAKERS(6 )
CENTER
SPEAKER(6 )
SURR. BACK /
SUB WOOFER(6 )
Surround right
(Front)
Center
Surround left
Front left Front right
Surround
back
• Plug this cord into a wall AC outlet.
SUB
-
WOOFER
OUT
FRONT SURROUND SURR.BACK
SUB WOOFERCENTER
IN OUT
VIDEO
TAPE 7CH DIRECT INPUT
SURROUND
SUBWOOFER
FRONT
CENTER
7 CH DIRECT OUTPUT
Decoder with 6 or 7
channel outputs
RRLL BACK
• Use these jacks to connect the corresponding analog out-
puts of a DVD player or external decoder, etc. that has 6 or
7 channel outputs.
In case of 6 channel outputs, do not connect this SUR-
ROUND BACK input to your component.(For details, refer
to the operating instructions of the component to be con-
nected.)
• To emphasize the deep bass sounds, connect a powered
subwoofer.
Note : When there is not surround back speaker, you can
connect the subwoofer into the terminal of surround back
speaker. In this case, you should change the subwoofer
speaker setting. Refer to “Adjusting the speaker settings” on
page 19.