Filter
Top Products
27
Adjusting the LFE level
Press the SETUP button for more than 2
seconds, then it enters the setup mode.
While displaying the setup mode, press
this button short repeatedly until “DD L”
is displayed.
1
SETUP
MEMORY
• You can adjust the LFE(Low Frequency Effect)
levels included in Dolby Digital, DTS and MPEG
program sources.
DD L DTS L
MP L
While displaying “DD L”, each time the
button below is pressed, the mode changes
as follows:
2
DECODING
TUNE MODE
(Dolby Digital LFE) (DTS LFE) (MPEG LFE)
• The Dolby Digital LFE level can be adjusted within
the range of -10~0 dB and other LFE levels within
the range of -10~+10 dB.
• In general, we recommend the LFE level to be
adjusted to 0 dB.(However, the recommended LFE
level for some early DTS software is -10 dB.) If the
recommended levels seem too high, lower the setting
as necessary.
• When using this function with remote control unit,
press OSD button and refer to page 38~40.
While displaying the desired LFE mode,
adjust the level as desired.
3
ADJUST
TUNING/PRESET
• The LFE level can be adjusted and applied when Dolby Digital, DTS or MPEG program source
is inputted. In case of other program sources, this mode is adjustable, but not applied.
Press the SETUP button for more than 2
seconds, then it enters the setup mode.
While displaying the setup mode, press
this button short repeatedly until “TONE
OFF” or “BASS” is displayed.
1
BASS TRBL(treble) TONE ON
• While displaying “TONE OFF”, you cannot adjust
the tone. To adjust the tone, first perform the step 3
and change “TONE OFF” to “TONE ON”.
While displaying “BASS”, each time the
DECODING button is pressed, the tone
mode changes as follows:
2
Adjusting the tone(bass and treble)
SETUP
MEMORY
DECODING
TUNE MODE
ENGLISH