Filter
Top Products
43
ENGLISH
Appendix
INITIALIZING THE SYSTEM
• When the display is not normal or when the operation of the unit does not shows the reasonable result, the
initialization of this unit is required by the following procedure.
After seeing the flickering standby indicator,
take your hand(s) off from buttons.
In standby mode, press SETUP and
DECODING buttons at the same time.
SETTING UP THE SYSTEM ON FRONT PANEL
• You can adjust the system settings in succession according to your system using the buttons on the front panel.
• This section explains how to adjust the settings using the buttons on the front panel.
• Refer to the corresponding pages indicated in ( ) for details about each mode and use of remote control.
Press the SETUP button for more than 2 seconds, then it enters the setup mode.
While displaying the setup mode, each time the SETUP button is pressed, the setup mode changes as
follows:
1
While displaying the selected setup mode, each time the DECODING button is pressed, the setting mode changes
as follows:
2
While displaying the selected setting mode, each time the ADJUST UP(
) or DOWN( ) button is pressed, the
mode is adjusted to the desired setting.
Notes:
• Only when selecting preset channel levels, press ADJUST UP(
) or DOWN( ) button to change the setting
mode and DECODING button to confirm your decision(refer to page 26).
• If the display of the corresponding mode disappears, start from the step 1 again.
• To help your understanding, each setting operation is explained with using its default setting.
3
SETUP
MEMORY
DECODING
TUNE MODE
1
2
ENGLISH
• If this unit has been reset, all the button settings
are reset to the default values (the values set upon
shipment from the factory).